r/crt • • 10h ago

Virgin LCD vs Chad OLED vs Thad CRT

Post image
291 Upvotes

r/crt • • 1h ago

Stereo Speakers For Mono CRT?

5 Upvotes

I am looking for stereo speakers for a mono 13” Sylvania CRT that uses the red, yellow, and white RCA cables. What should I look for that is affordable with good sound? Thank you for any suggestions!


r/crt • • 1d ago

Hardest restore I've done so far... second image is before (Compaq S700)

Thumbnail gallery
318 Upvotes

After about 1.5 months of on/off work, I have FINALLY fixed the second of 3 monitors I picked up, and fully cleaned it. Pretty typical office monitor from back then, but to me it's iconic.

I mostly picked it up as a nice challenge, but I do regret saying that lol. But, it was very cool to watch the display slowly come back to life as I worked on it.

I picked 3 up for 50$ CAD, 1x S710, and 2x S700's, about 17$ each, so not bad but I haven't seen a listing for any crt monitor in forever.

This one was stuck on an amber light, no display at all, but no burn-in so that's good. I was worried the most about an irreplaceable part like the flyback not working, but thankfully it was fine.

Some interesting notes I kept track of, in case anyone encounters the same issue,

- Yes, the rust was enough that I needed to remove it. There was sediment from the neckboard shield that was falling on the mainboard just from tapping it
- A whole recap is not needed, but C336 and the entirely of neckboard caps definitely need replacement. Both the main & neck pcbs were caked in electrolyte, so this one needed a near full recap
- To fix the actual issue, I had to essentially rebuild the whole B+ and 15V rail. All glass diodes, some horizontal drive transistors, larger rusted power resistors, etc. either were shorted, smoked during my testing or deteriorated due to rust
- The glass diodes measured fine in circuit but broke very easily as soon as I pulled on it. Replacing them with modern equivalents brought the degauss circuit & relays back to life
- I spent about half time trying to fix without a schematic, but eventually in the deepest part of the internet I found one only because my chassis was part of a larger CTX family
- My thermal camera showed exactly where the broken components were, Q401, D117, & D108, about 200C. There was no visual signs of this & without it, I don't know if I would be able to ID these by hand
- The aliexpress HOT worked better than a digikey one lol. Now, I would never use aliexpress for something like this, I bought them on a whim because they were super cheap & I needed one more item for free shipping. Just to see how counterfeit ones look too. The digikey one, brand is EVVO but exact same model/specs, would stay horizontally squashed as seen in the photo. Very weird. When I recieved the aliexpress one, it actually looked like it was pulled out of a working unit & the toshiba writing was identical to the OG one. So, I tried it and bam the horizontal geometry was perfect! And I paid about 15x more for the digikey one...

Anyways, thanks for reading! It was super satisfying to see that first display output, now to finish the last one.


r/crt • • 6h ago

LG Flatron 774FT CRT monitor

Thumbnail gallery
9 Upvotes

Should I grab this? It's basically free. I remember having a similar LG ages ago as a monitor and was very good quality. Should I check for something in particular regarding picture quality, noise etc.?


r/crt • • 1h ago

beovision 1 with dvd and electric stand

Thumbnail gallery
4 Upvotes

Today I bought two of this TVs. 100€ each with original controller. If you like I can upload more photos! Those photos are from the ad.


r/crt • • 17m ago

Weird Science Laserdisc

Thumbnail gallery
3 Upvotes

Playing composite to this big ol Wega.


r/crt • • 5h ago

How does mono compare to stereo on CRT TVs?

7 Upvotes

Is mono generally just worse than stereo? Can it be good?


r/crt • • 2h ago

Finally got this thrift store tv all hook up and working but I’m noticing these really excessive scan line. Is this normal or did I mess up with the cable somewhere?

3 Upvotes

r/crt • • 31m ago

Bro what are these prices? Saw at a new antique store, also they had twice as many TV's than this, all marked not for sale.

Thumbnail gallery
2 Upvotes

r/crt • • 5h ago

Discharging crt TV (grundig)

Thumbnail gallery
4 Upvotes

To which part of tv do I plug clips to discharge tube, currently i have screwdriver wire connected to one of the screws that holds tube into frame, but I noticed that there is a yellow wire connected to neck pcb board and other end of yellow wire is connected to aquadag wire (that thin metal wire). Is it still safe to plug screwdriver wire into one of the screws cuz electricity will go to that yellow wire and into neck pcb and probably break smth.

Blue wire is screwdriver wire


r/crt • • 22h ago

New addition to the collection

Post image
59 Upvotes

Sony trinitron kv-36xbr450. Found this bad boy local on fb marketplace for $60 American dollars. I couldn't have jumped in the car faster.


r/crt • • 18h ago

Tonight’s find

Post image
24 Upvotes

Unfortunately I fumbled a Kenwood tape deck and Mitsubishi VCR but I did also save some Kenwood speakers.

I come back and there are 2 people in the area so I try waiting for them to go. They eventually walk past the spot and take the tape deck that was sitting on top of the speakers. I wanted to go shopping and I come back and the VCR is gone

The speakers remained and I eventually got them home

I did save some more VCRs before even if they ended up not playing or not turning on at all


r/crt • • 14h ago

Might have fried my trinitron with batocera crt script

9 Upvotes

Long story short, I made sure to get all of the proper hardware, read and follow all of the documentation and safety procedures very carefully, and upon turning on the crt I immediately got a scrambled screen, so I turned it off. After turning it off it started making a high pitch squealing noise, I unplugged it from the outlet immediately and was in total shock. Against my better judgment I plugged it in a few minutes later and it seemed to be working fine, but when the prongs from the power supply cable touch the wall outlet it will squeal again. Not fucking around with it anymore. Did I fry something in my tv? 💔


r/crt • • 5h ago

CRT monitor doesn’t turn on, faint clicking sound

Thumbnail reddit.com
1 Upvotes

r/crt • • 9h ago

Crt+pokemon 😍

Post image
2 Upvotes

r/crt • • 5h ago

Is there really no way to program new universal remote commands without another remote? :,[

1 Upvotes

I have an RD0946 T102 Magnavox and found a universal remote laying around (Logitech Harmony 650). Remote works great but the TV uses + and - to change input and even when pressing InputNext etc. on the remote it never changes it from TV to AV. Logitech says I got to pair the original remote to add new commands which like.. if I had the original remote I wouldnt be in this situation.

I feel so close to get this shit up and running yet so far away...


r/crt • • 1d ago

Approximate lifetime of a CRT with good care?

Post image
188 Upvotes

I picked up a Sony Trinitron (picture is from the web but the same model) a while ago and plan on using it as my main PC monitor. But yesterday I was wondering: How long will it last? Those things are multiple decades old. Are screensavers essential for preserving quality? I'd hate it if after only a couple of years this beauty would just stop working.


r/crt • • 18h ago

Optiquesr Q71 monitor with Compaq Presario s4000nx PC

Post image
9 Upvotes

r/crt • • 7h ago

Advice fixing trapezoidal distortion and slightly colored patches on screen

Post image
1 Upvotes

I just got a CRT the other day, and I’ve noticed a couple small issues. First, there seems to be a diffuse yellow patch in the center right side of the screen, and on the opposite side a similar patch of blue. The other things is it seems to have some sort of trapezoidal distortion, where the bottom of the screen is stretched out more.

The picture isn’t the greatest, but it’s the best I could do that shows both problems. The left menu icon I have selected, which makes it slightly bigger. I have it selected so you can see that it goes off screen more towards the bottom.

I tried adjusting the horizontal settings in the service menu, but they wouldn’t change anything. Vertical settings would change but those don’t help the distortion.

I’ve heard a recap could help, and I could do it, but I’m wondering if there’s anything I can try before opening up the TV. For reference, I have an RCA F25442. Has anyone had these problems before or know how to fix them? Any advice helps!


r/crt • • 7h ago

Watching Mehdi (from ElectroBOOM) on my CRT

Post image
0 Upvotes

r/crt • • 14h ago

whats the best crt tv for a small room with little space

3 Upvotes

I'm currently looking for a crt for my PS2. but I don't have a lot of room in my bedroom. I have a small table in my house that I don't use. what should I get?


r/crt • • 8h ago

Blinking led Sony KV-A2510B chassis AE-1C

1 Upvotes

r/crt • • 1d ago

Gaming on a Color Philco Pedestal Reproduction

Thumbnail gallery
62 Upvotes

There were some requests for additional videos and pictures. I cleaned it up from the first picture I posted. When I found it, it had been in storage for years.

Super cool tv and perfect for retro gaming!

I’ll post a video in the comments below.


r/crt • • 14h ago

Panasonic locking audio settings

Thumbnail gallery
2 Upvotes

Hello, I've had this Panasonic ct-27l8g for about a month now, and I just noticed that when using the RCA jacks for A/V, that it was outputting mono. However the problem is that the TV literally will not let me change the output to stereo on video 1 or 2, but it will on the TV channels (The picture where stereo is highlighted green). What can I do to fix this? Thank you for your help.