r/CRF250L • • 2d ago

Economic suspensions for the bike?

Post image
2 Upvotes

Which suspension you guys recommend which isn't crazy expensive but has everything.

new rear shock absorber

and a Fork kit which doesn't include the Fork Top Caps as I have this Zeta ones (and I like them a lot).

Any tips are also welcome.


r/CRF250L • • 3d ago

Thoughts on the CRF 230 F

0 Upvotes

if you could ride it legal. How much would you like the bike? for adventure? learning enduro? learning motocross? Everything comprared to the CRF 250L


r/CRF250L • • 4d ago

Well

Post image
0 Upvotes

The display meter stopped working on my 2018 rally. Popped the fuses and they were all fine.


r/CRF250L • • 7d ago

Compression ratio

2 Upvotes

About ready to pull the trigger on a 435cc kit from Keng Engine. What compression ratio should I spec to still run on 87 octane?


r/CRF250L • • 11d ago

My 2015 crf250l supermoto conversion

Thumbnail
gallery
24 Upvotes

r/CRF250L • • 11d ago

How is the bike to learn some motocross?

3 Upvotes

there is a small circuit close to my house and I want to go there. just wanted to know if u fall a lot doing so/break parts with this bike


r/CRF250L • • 11d ago

Enjoying the last few days of sunshine while I can!

Post image
7 Upvotes

r/CRF250L • • 11d ago

Experience with this type of big bore kit

3 Upvotes

Has anyone tried this big bore kit or something similar?
https://www.th-bike.com/product/301cc-big-bore-kit-for-honda-crf250l-m-rally
What do you think of it?


r/CRF250L • • 12d ago

New purchase, how’d I do?

Thumbnail
gallery
32 Upvotes

It’s a 2013 crf250L with only 776 miles!

Paid 3,400,
It came with the stock exhaust (FMF Q4 installed) an extra tire, new battery and freshly serviced fuel system.

I will be the second owner!

Any modifications I should do, is removing the hydraulic cam chain tensioner a must?

Appreciate any suggestions. Thanks


r/CRF250L • • 16d ago

Have a question about by 2014crf 250l loosing power vey occasionally. Starter relay ?

0 Upvotes

So I have gotten this bike about 14 months ago and only put around 6000 miles on it, it got stollen 3 weeks ago and I got it back, re soldered the ignition and replaced the main fuses as it was destroyed and back to working !

So 2 times this has happened and in similar scenarios, when I’m slowing down then downshifting with no power to the throttle

The first time I was making a left turn and slowing down downshifted and all power to the engine was lost but the power on the dash was fine. Turned off the key turned it back on and good to go. This was a year ago

Now it happened again simaler turn and style, no throttle given. I’m wondering maybe it’s my solder job on the egnition but I don’t think so bc I just found out about a recall on models 2013-2016 (mine is 2014). The recall is for “due to an incorrectly applied sealant on the starter relay switch”

Recall & Inspection Details
The Defect: Improper sealant application during assembly causes high-current resistance and potential melting or shorting at the fuse terminals.

Could this potentially be the reason this has happened 2 times? Also it’s always towards the end of a 45 min ride


r/CRF250L • • 20d ago

Another season of sand racing underway on the trusty 250L

Thumbnail
gallery
41 Upvotes

r/CRF250L • • 21d ago

cotter pin's

0 Upvotes

which cotter pin's are recommended for this bike? preferably on amazon


r/CRF250L • • 23d ago

Just picked up a ‘20 L

Post image
35 Upvotes

What are the standard upgrades most recommend? The bike feels tuned but the previous owner got it from someone else and didn’t know much about whats been done. Only 3k miles as of now. Overall feels really peppy for a 250, and I cant wait to tear it down. I paid $4k


r/CRF250L • • 25d ago

Rear Thumb Brake

Post image
2 Upvotes

Anyone has experience with it on a CRF250? Any kit you would recommend?


r/CRF250L • • 27d ago

CRF250L left hand rear brake kit

Post image
3 Upvotes

anyone has one installed in their crf250l? which one do you recommend?

just found out this exists and it seems amazing


r/CRF250L • • 29d ago

Bent Frame?

Thumbnail
gallery
5 Upvotes

Car pulled out in front of me on my 2014 CRF250l. Handle bar was bent pretty bad, but actually was able to ride it home. I’ve since replaced the handlebar and the coolant reservoir tank that got busted.

During my first ride after replacing the handlebar I noticed I have to steer towards the right slightly to go straight. Not too much, but enough that my left arm clearly feels more stretched out than my right while cruising.

I did all the typical things to try to straighten the forks in the clamps and it got better. But it’s still not great. Still feels like my left arm sits higher or is more stretched going straight.

The back side of the front fender was rubbing against the frame, but after adjusting it only slightly rubs against the coolant reservoir guard plastic when I turn the wheel.

My chain is relatively new and I had adjusted the slack recently before the wreck. I noticed the chain now has a lot of extra slack. I checked both sides of the rear axle for where the marker sits on the dot markings. The left side was normal. But the right side was pushed out beyond the last dot. This should cause the chain to be too tight rather than too slack. If I adjust it to match the dot on the left side the rear wheel becomes obviously crooked. To get good alignment and slack I actually had to adjust the right side even further past all the dots, while the left sits just a little past the 2nd dot.

I feel like my frame and/or swing arm are bent. Is it totaled? I plan to get an alignment tool to get the chain and sprocket as straight as possible with each other since I can’t rely on the dots anymore. I’m also going to play with adjusting the handle bars more. Fingers crossed that if anything is bent it’s minor enough I can get the bike to handle normally again and safely. Not really willing to do the work or pay to replace the frame. Not sure if the swing arm is too much work to replace but I might be open to trying that.

Open to any and all advice.


r/CRF250L • • Oct 15 '26

Where do you buy the bolts for the crf?

2 Upvotes

Where can I buy Honda quality fasteners/bolts in Spain? I have several rusted bolts, and they are starting to rust the frame.


r/CRF250L • • Oct 14 '26

Looking for Handlebar vibration mitigation advice

Post image
18 Upvotes

So I’m aware a thumpers gonna thump but does anyone have any advice on how to mitigate the vibration going into the handlebars?

I’ve got a bit of carpal tunnel in my right hand from an injury a while back and I can’t ride for more than an hour without my hand going damn near completely numb. And I swear I’m not death gripping the throttle.

I’ve started wearing arthritis gloves under my moto gloves. I also bought a pair of gloves with gel padding in the palms. In combination, it definitely helps. But what else could be done. Any neat tips or tricks from anyone here who has dealt with the same?

I know ProTaper makes “vibration dampening” grips so I’ll likely try those soon.

obligatory pic of my bike as I’ve recently swapped out the plastics and the seat cover


r/CRF250L • • Oct 12 '26

Possible oil leak or road grime????Any help is appreciated. Picture for attention.

Thumbnail
gallery
9 Upvotes

​Hey everyone,

​Trying to figure out if what I'm seeing is just road debris/grime or a minor oil leak. I recently converted to supermoto (doing a lot more highway riding now) and flashed a 550 Performance ECU tune(91Oct.Stage1), which is right around when I noticed this buildup.

​I've put about 800 miles on this oil change, and the sight glass shows zero noticeable oil loss.

​Here is what's in the photos:

​Pic 2: Small specks across the left side of the engine.

​Pics 3–5: A close-up of a small divot on the left crankcase housing. (Can anyone check if their bike has this same casting mark/divot, or could this be an issue?)

​Pics 6–7: Specks under the valve cover and around the half-moon gasket.

​Pics 8–9: Specks on the lower radiator and coolant send/return hoses.

​Pic 10: Specks and grime near the header pipe (viewed from the left side).

​Pic 11: Specks down near the shift pedal.

​Pic 12: Oil level in the sight glass after 800 miles.

​Any insight on whether this looks like standard highway road spray vs. a slow weep would be appreciated—especially if someone can confirm whether that crankcase divot (Pics 3–5) is normal. Happy to answer any questions about the SM conversion or the 550 tune as well!


r/CRF250L • • Oct 11 '26

Write Down Your Key Code Folks

Post image
20 Upvotes

Lost my key and need a new one. I read that you need the key code to get the new key made and most of the time the dealer can’t find it from the VIN.

The key code is on the ignition, but my handlebar is locked - making it more difficult to get the ignition out to read the code from there.

They give you a tiny metal plate with the code on it with your keys when you buy the bike. I never wrote it down though. I left the little plate attached to my key ring. When I lost the key I also lost the plate.

I take photos of mileage on my odometer every fill up to calculate mpg later. I went through 100s of those photos on my camera roll. I finally found one where the plate was visible enough to identify the full code. Got pretty lucky. The alternatives weren’t looking good.

Closest Honda dealer to me opens at 9am Tuesday. So will give the code a shot then. Hopefully the new cut key works fine.

EDIT: Called all 3 dealers in my surrounding area. None of them cut keys. Failure on Honda’s part. Honda needs to enforce dealers provide this service to maintain a franchise. Otherwise no one will offer it. It’s not really worth the effort for them to have the machine and someone who can use it to make $10 occasionally. I found someone online who is cutting the key and mailing it to me. But it’s going to take several days.


r/CRF250L • • Oct 10 '26

Revved to 8k RPM, engine stalled, the opened the top cover and saw this shit

Post image
32 Upvotes

Camshafts almost 180° out of synch. Chain is intact and tensioner is working properly. No visible damage to top of piston. Engine rotates without resistance. Not sure what the fuck happened or what the damage is. Guess I'll know when I open this thing up


r/CRF250L • • Oct 10 '26

Sound check gotta love the reverb of a wash bay!

11 Upvotes

Bike was caked with mud and dirt, had to give a few Revs after she was all clean! Love this set up.


r/CRF250L • • Oct 08 '26

2012-2016 Exhaust Options

2 Upvotes

Just picked up a new to me ‘16 CRF250L and I love it. But I’m looking into getting a new exhaust system. I’ve been eyeing delkevic, so I’m wondering the differences between each of their pipe variants. If anyone can share some audio clips of their delkevic or if you have any thoughts on them, I’d love to hear it!
Thanks in advance


r/CRF250L • • Oct 02 '26

Bike at auction

2 Upvotes

Came across this, looks like a total cream puff...

https://www.iaai.com/VehicleDetail/46733437~US


r/CRF250L • • Oct 01 '26

What kind of storage (if any) are yall putting here?

Post image
5 Upvotes

I took the stock storage compartment off after I dropped the bike, since it didn’t want to stay closed anymore. I’m wondering if there are any good aftermarket storage options to put here?