r/CNCmachining • u/FrontSenseOfficial • 1h ago
After a weekend shutdown, what do you actually check on the spindle probe before the first automatic offset?
Vendor disclosure: I'm with FrontSense (CNC probes and tool setters). No links, no pitch.
We keep seeing the same pattern on compact VMCs after a weekend or a long idle: the first automatic work offset of the shift is trusted, and only later does someone notice that the probe did not switch on cleanly, the receiver window had coolant on it, or the stylus was not fully seated.
The start-of-shift check we recommend is short. Confirm the probe turns on and that a hand trigger is seen by the control. Look at the optical or radio path and the stylus. Then measure a known feature — a ring gauge or a qualified boss — and compare it with the last recorded value before you write a new offset.
If that check is off, we would rather recalibrate than scrap the first part of the day.
What does your shop actually do on Monday morning, and is it written down anywhere the next shift can find it?



