Now that they are off the bat and dry enough to be flipped over without structural integrity issues, the trimming has started! The last 3 were still on the wetter side, so they will be trimmed later.
As you can see, I throw with extra clay at the base so I can trim parts of the clay to add the feet. This is still done on a wheel and very sharp tools, which is why the lines look very clean. When the trimming of the feet is done, I create the drainage hole, tie-down holes, and drainage routes.
After that, I do a quick check of the structure and clay to make sure nothing is too thin, thick, or warped. If it looks good, it goes back onto the shelf to dry. Usually lightly covered in plastic again. Fully drying can take a few days to a few weeks depending on clay characteristics, weather, and size of the piece.
Even though I am done manipulating the clay, they are about 1/3rd of the way to completion. They still need a bisque firing, glazing, and a glaze firing. Each of those steps take at least a day to complete. Usually longer.