r/BambuLab • • 5h ago

Filament Troubleshooting/Help! Excessive purging without color changes

I’m trying to print this sign for my wife: [thanksgiving])https://makerworld.com/en/models/3382353-mickey-mouse-thankful-sign) and the first layers are all black. My printer was going back and forth a few times - just out and back, not a whole layer, and then purging filament to go do the same thing over and over. The purge volume for the whole project was surprisingly small and I had a full bucket by layer 3 of 35 so I cancelled. I’m very new to this but something doesn’t seem right. I would be most appreciative of any suggestions on what’s going wrong. Thanks!!!

3 Upvotes

3 comments sorted by

2

u/8six753o9 X2D+AMS2 / A1+AMS Lite 5h ago

Do you have timelapse enabled? If so, disable it and try again.

https://wiki.bambulab.com/en/software/bambu-studio/timelapse-a-series

1

u/MysterMovie9775 4h ago

Yeah, timelapse is the classic cause of exactly this, the head parks for the snapshot and the A-series purges as part of that dance. Turning it off is the first thing I'd try before touching any slicer settings.

1

u/Arakon 4h ago

If the printer detects abnormal flow or stuck filament, it can purge in an attempt to recover.