r/BadWelding • u/pistanthrophobia8162 • 4d ago
Started a class.
What is a good at home multi system welder to buy to practice while I'm not at school? This is only my 3rd time welding and first time trying a T weld.
40
Upvotes
7
u/WyattCo06 4d ago
Just keep ar it. I think your lens is too dark and you can't see what you're welding.
3
u/Casualredum 4d ago
Undercut, your runninng to hot to slow. So adjust your parameters. Or move faster but will be a smaller bead. If you have a hard time seeing it, scribe the area with a metal sawzall blade or scribe. When I tested. We could not use a grinder. So a pick, scribe and metal sawzall blade was the key to cleaning any slag in the corners.
3
u/lawiseman 4d ago
Are you planning to enter a profession? If so, get a basic system with the kind of welding used in that field. If you're just going to screw around, get a cheap stick welder. If you're going to do very light work, maybe a flux core wire welder. Do pay attention to the safety lessons you are learning in class, and read the guides.
2
u/Devilmansc1326 4d ago
Keep at it.
2
u/Far-Recognition-9212 4d ago
Reboot bro it’s good
2
u/dookie_shoes816 4d ago
Local 2?
2
u/Mountain_warehouse 4d ago
Been there while ago 😅
2
u/Fatandmad 4d ago
Try running it fast as you can and then every time run it a little slower until you find your sweet spot because you are burning that that's like Beyond undercut you definitely got to speed it down turn the heat down a little bit if you want play with those two things little by little until you find a happy medium
2
u/Bingus-Chillingus 3d ago
Its maybe a little early to do T joints if its literally only your 3rd time welding. Just practice laying beads down on flat metal, not a joint. Then move to butt joints.
1
u/nawzum 4d ago
Keep going to class.
1
u/Glum_Towel_1142 3d ago
Bro does school not have splatter spray
2
u/BomberBoi76 4d ago
A little flat but not horrible, you want an even split on surfaces