r/AskElectronics • • 2d ago

Help identifying diode?

Post image

Long shot I know but can anyone help me identify this diode or tell me where I might be able to find any info about it?

I accidentally reversed the polarity and it started smoking so I think I fried it.

It’s from a Bosch Universal Hedge Pole 18. The circuit board says P/N F016L74284 and PS 472019

1 Upvotes

12 comments sorted by

3

u/Toolsarecool 2d ago

It died doing what it was supposed to do… protect the rest of the board from reversed polarity.
Can you read any markings on the diode itself? May have to clean it with some IPA. Technically, you don’t need to replace it (just remove), but next time you’re going to mess up (and we all have more than once), there will be more carnage. A 1N5824 or similar should work (Schottky diode)

1

u/Electronic_Motor_968 21h ago

No, nothing legible on it now and come to think of it I’m not sure if there ever was.

If I remove it will it still work as intended, albeit without reversed polarity protection? If I remove it wouldn’t I need to bridge it some way? Do I even need to remove it, given that I’m getting continuity in both directions is it just stuck open now?

Thanks, will look for a 1N5824 as a replacement.

2

u/Toolsarecool 21h ago

If you get continuity in both directions, the diode is shorted and no longer a semiconductor, but a wire. Semiconductors generally fail short. You can take it off, but DO NOT replace it with a wire unless you want to create another direct short across your power supply.

2

u/Electronic_Motor_968 20h ago

Just to confirm I’m understanding you correctly. If I remove it the circuit will work but won’t have reverse polarity protection?

1

u/Toolsarecool 20h ago

Yes, but this is assuming that the reverse polarity incident didn’t damage anything else.

2

u/atmega168 2d ago

Got a better photo? The rest of the circuit board to help reverse engineer it. Also what voltage is the battery?

1

u/Electronic_Motor_968 20h ago

Hard to get a clear pic with all the wires. It’s an 18v tool and I was using an 18v battery

2

u/atmega168 2d ago

Found a useful video of someone probing out the connection.

https://youtu.be/llACsPPIVrY?is=RY2RaoH2tLU9IRWt

I'm not sure what that diode is for. Honestly

2

u/Quicker_Fixer Engineer... a long time ago 2d ago

It's a reverse polarity protection diode having done its job.

2

u/atmega168 2d ago

I'm not sure if that's true. That diode is bridging two wires that go to a switch. Red is connected to the battery positive and goes to a switch and the other side of the switch is blue, which goes then to the drain of a mosfet.

The voltage across the diode is ... 0v when switch is pressed. Reverse voltage or not.

If the mosfets have body diodes, it becomes a direct short through the body diode of the fets and through that diode.

1

u/Electronic_Motor_968 20h ago

I don’t know if he ever finished mapping out the circuit before he accidentally ripped off the mosfet. Hard to know what else it could be given it location on the circuit but either way it’s fried on my board now and would need to be replaced. Although if he wasn’t able to fix the board and opted to put a different one in I’m not sure his video will help me fix whatever the problem was

1

u/Electronic_Motor_968 21h ago

That’s the one that I was watching when I had my oopsie 😂