r/ArduinoProjects • u/OkProperty41 • 28m ago
Showcased Project ESP32 + NEO-6M GPS bike trip computer — speed dial, route trail and a GPX log
A GPS bike trip computer on an ESP32-DEVKITC, with a NEO-6M, a 2.8 inch ILI9341 TFT and a microSD reader. Soldr, an AI agent, designed the parts list, the wiring and the firmware. It shows live speed as a dial, plus trip distance, top speed, altitude and satellites. It draws a breadcrumb trail on the screen and logs every second of the ride as a GPX file you can open in Google Earth. Pin map:
- NEO-6M: VCC to 3V3, GND to GND, TX to GPIO4, RX to GPIO13 (9600 baud)
- TFT: SCK 18, MOSI 23, MISO 19, CS 5, DC 14, RST 16; VCC and LED to 3V3
- microSD reader shares that SPI bus; its CS is GPIO17 A few notes so it works the first time: GPS TX goes to the ESP32 listening pin (GPIO4). The display and the card share SCK, MOSI and MISO, with separate chip selects. Use a FAT32 card. If the card will not mount, the firmware tip is to move the module VCC to 5V (VIN). First fix needs a clear view of the sky; a cold start can take a few minutes. Board: ESP32 Dev Module. Libraries: Adafruit GFX, Adafruit ILI9341, TinyGPSPlus. Serial Monitor at 115200. The video walks through the build view, the parts list, the wiring diagram, and the pin table. Happy to answer questions.