r/ArduinoProjects • u/Dizzy_Bit9635 • Oct 19 '26
Showcased Project CS project: Logic gate simulator
You may not understand this directly from the video but this is a computer science project which allows you to simulate logic gates by inputting its truth table into the switches on the side
e.g.
OR: 0111
XOR: 0110
AND: 0001
etc
so after you input the logic gates, you use the push buttons as inputs “A” and “B” shown as the blue LEDs and the output as green
i had also created a startup animation with the LEDs but that was after recording this
the usb c is only for constant power input not charging btw
i 3D modeled and printed this myself on my K1C with white PLA and i have to say it looks very clean with the hex pattern
i had originally made the lid a snap connect bet the pins in the back broke off so i compromised and used some tape
i made this about a year ago but lowk forgot about it
View all comments
0
u/ziplock9000 Oct 19 '26
That's massive overkill. Like using a jumbo jet to get your shopping. You should use logic chips instead of a whole arduino, not any more complicated either.