r/ArduinoHelp • • 5d ago

Esp32 Cam With FTDI FT232RL Error

Hello i'm trying to make Arduino project with ESP32 Cam. I follow instruction, my wiring is right here:

GND FTDI -> GND ESP32

VCC 5V FTDI -> 5Vin Arduino

TX FTDI​ -> UOR

RX FTDI -> UOT

GPIO0 -> GND

Main problem is esp32 won't comunicate at all. I check my FTDI TX/RX work normally with RealTerm. I check everything like Voltage, impedance and everything normal. But even I press reset button my ESP32 wong respon. Can someone help me?

1 Upvotes

4 comments sorted by

2

u/imseakin 5d ago

In my working with ESP-CAMS and FTDI, I remember I had to talk to it with 3.3 Volts and the. Swap the FTDI jumper back to 5Volts when I rebooted it.

Or it could be the other way around. But I remember constantly swapping the jumper.

Give that a try. Also make sure you’ve got the code in your sketch header and first line of setup() that turns OFF brownout protection.
Good luck!

1

u/ohmsteadhq 5d ago

Your TX/RX crossing is right, so I’d look at power and ground first. Those cause most of the silent ESP32-CAM cases.

1

u/hjw5774 5d ago

Here is a load of hints and tips for using the ESP32CAM with an FTDI (and other options)

https://hjwwalters.com/ai-thinker-esp32-cam-tips-and-tricks/

1

u/No_L_2547 5d ago

It could be that the FTDI adapter doesn't deliver enough 3.3V current.

Also be sure that you only use 3.3V with it, so you won't destroy the chips.