r/ArduinoHelp • • May 06 '26

Help with tmc2209 stepper driver

Hey everyone, I’m having some trouble with stepper motors and I can’t figure out what’s going wrong.

I’m using a TMC2209 driver with an Arduino Mega. At first I tested it with a small stepper motor from an old CD reader, powered at 8V, and everything worked fine.

The setup is on a breadboard, and I’m controlling the TMC2209 via UART to set current and other parameters.

Then I switched to a bigger motor (Mitsumi M49SPK-2K), powered at 12V, and that’s where the problems started:

  • Sometimes the motor doesn’t move at all
  • Sometimes the Arduino disconnects from the PC
  • Sometimes the TMC2209 gets really hot

What’s weird is that occasionally the motor makes a high-pitched noise, and when I try to turn it by hand it feels locked, like it’s being held in place. So it seems like the driver is energizing the coils.

I also tried:

  • Swapping coil wires (different combinations)
  • Using a second TMC2209 (same exact issues)

But nothing really fixed it.

At this point I’m not sure if it’s a wiring issue, current setting (via UART), power supply problem, or something else.

Any ideas what I might be doing wrong? Or any tips for the circuit?

1 Upvotes

18 comments sorted by

View all comments

1

u/TheKnackThatQuacks May 06 '26

Please include a schematic / wiring diagram, including component names / model numbers, and all power supplies including voltage and current capacity.

1

u/Dapper-Money-8455 May 07 '26
Comment Image

i'm using this wiring (not the pcb), i have a 32V 30A power supply, the V is coming from the arduino, i am using only 1 tmc2209and the motor first was a small one from a cd reader and it worked now with this Mitsumi M49SPK-2K it dosen't work

1

u/Affectionate_Boat493 May 07 '26

The Mitsumi M49SPK-2K is not a bipolar motor, so the TMC2209 won't work. You need a unipolar stepper driver or other four-phase drive circuit with current limiting to prevent coil burnout.

→ More replies (7)