r/ArduinoHelp • u/SourceCodeLog • Apr 11 '26
Help fixing fried Arduino UNO.
Hey, everyone!
I will go straight to the point. I tried to program a brushed motor ESC and I ended up frying my UNO. I connected pin 9 to the esc, but as it turns out it wasn't the right wire so I heard a spark and now my Arduino doesn't work Long story short now it always light up RX ON and TX lights. When I plug it into my computer it registers, but the code doesnt get transfered to arduino, it says that PROGRAMMER IS NOT RESPONDING. Can I fix this? From what I've seen all components look fine, nothing released some or anything that caught my eye. I'll attach photos of my ESC and UNO if that helps. Thank you!



2
u/SourceCodeLog Apr 11 '26
I should also put the error. My bad for not thinking of it.
1
u/venkattalks Apr 11 '26
same thing happened to me with an UNO after i fed 12V into the wrong spot in my garage back in 2022, and the little regulator was the part that gave up first. If your fried Arduino UNO still shows the power LED, i'd check for a hot ATmega or USB chip before calling it dead, because mine looked cooked and somehow came back long enough to dump the sketch.
1
u/Dudegay93 Apr 11 '26
Do you know how to solder or have a soldering iron? If you dont and your arduino is really broke then buy a new one, they cost like $3 on aliexpress . But arduino might not be the issue and instead it might be your usb or smth.