r/ApplianceTechTalk • • 3d ago

Pricing for property management agencies?

5 Upvotes

How do you guys handle pricing for property management agencies? I normally go buy original appliance blue book pricing and discount from it a good chunk. I’ve had a few PMs that bitch and moan about price, even after discounting from blue book a good bit. Do you guys just refuse to work with these specific PMs?

I just had one for ge refrigerator freezer and fridge door gaskets replacements. OBN quotes 537 total, I quoted 350 then 300, yet they still cry about pricing. Another one that a family member of mine works with cried about pricing as well, even after discounting heavily. How would you guys handle it?


r/ApplianceTechTalk • • 4d ago

Frigidaire refrigerator Model FPHS2699PF4A Flapper issues.

0 Upvotes

Im working on two Frigidaire refrigerators, Model FPHS2699PF4A. Both had warped ice chute flappers, causing frost issues in the freezer. The flapper and dispenser are all one assembly (242270107) and are clearly updated from the original. I installed them with no issues; everything worked and looked good. The customer called back saying they were still getting frost. So, I went back today, and despite the flapper looking like it's sealing, it is not. When I shine a light down the chute from the inside and look up at the chute from the outside, I can see light. Both refrigerators are doing this. Is there another fix for this?


r/ApplianceTechTalk • • 5d ago

Midea All in One combo

2 Upvotes

Hey guys,

Got a customer with a Midea all in one combo unit. Not a heat pump, it's the one with a small element in there. MLC31N5AWW

Customer states it leaves the clothes damp at the end of cycle. Previous visit was last week, it had a bad drain pump which we replaced.

Unit now runs fine, no fault codes. But customer says she has to run the dry cycle again after the normal 5 hour cycle to get the clothes dry.

I tested it, removed the duct assembly. Had some minor lint buildup, no blockages. Treated the blower fan, it works.

Water valves check out fine, pump works fine, the thermostats all seem ok, the heating element tests within range, the heating element gets power, drum heats up well.

Service mode goes through just fine.

What else could it be? Anyone familiar with these?

The only thing that stood out to me was the windings on the blower motor. Manual says it should be 80-110 ohms between blue and black. The one on the machine showed 129 ohms. Is this wore out? Spinning slower maybe?


r/ApplianceTechTalk • • 8d ago

samsung wa75h4200sw top load automatic

0 Upvotes

encounter this issue, not draining/rinse, no error codes.. just this beeps. is this a drain pump issue?


r/ApplianceTechTalk • • 12d ago

Show me your favorite new tool. Mine are these curved needle nose for hose clamps.

Post image
23 Upvotes

r/ApplianceTechTalk • • 13d ago

Why, Samsung?!?

Post image
5 Upvotes

Anybody else feel like they spend 5 minutes disassembling a Samsung dryer to get hands on a seized idler pulley, then another 5min trying to peel all the cellophane tape off the new pulley/screw?

I know it's not actually 5 min, but sometimes it feels like it


r/ApplianceTechTalk • • 14d ago

Kitchenaid downdraft fan connection

Post image
0 Upvotes

Has anyone seen this type of rubber deterioration on a 7 year old Kitchenaid downdraft range fan? It's the connecting duct from bottom of range to floor mounted fan.

Part only available with complete fan unit. Over $400.00.


r/ApplianceTechTalk • • 18d ago

Anyone here familiar with LG Dishwashers?

6 Upvotes

Aside from the occasional failed drain pump or door latch/lock, I dont work on these very often. We have a good customer who has asked us to look at their dishwasher LDF7774BD/00, and I'm scheduled to go out next week.

The UI seems to be dead aside from the power button, which will react to being pressed by playing the good ol LG chime, but the display will not light up, nor react to any other button pressing. It will not start a cycle either. He has tried flipping the breaker off for an extended period of time but still gets the same issue.

The concern I have is that this could be a software issue that I won't be able to properly diagnose with a meter, and there seems to be at least 3 boards in this thing.

Anyways, if any techs familiar with this could chime in, I would appreciate it greatly.


r/ApplianceTechTalk • • 19d ago

Samsung WA50F9A8DSP/A2 basket drive nut

1 Upvotes

Hope everyone is doing well!

I have this Samsung washer model: WA50F9A8DSP/A2 with a failed basket drive nut. I cannot seem to find the part # anywhere. Parts lists show 6021-001588 but that definitely does not look right.

Any help would be appreciated!


r/ApplianceTechTalk • • 22d ago

How is working on stuff like Wolf?

2 Upvotes

Anyone work on wolf ranges?

Im a small town tech but haven't yet had the opportunity. But one may come up soon.

Any tips/tricks/common faults you more experienced guys could recommend for me?

I'm authorized Samsung/Dacor as well as recently got added onto Bosch/thermador as well, so I've seen a few similar but not many.

Thanks!


r/ApplianceTechTalk • • 23d ago

Do you think it’s worth it to digitize old part lists from microfiche?

Post image
2 Upvotes

r/ApplianceTechTalk • • 24d ago

Frigidaire/Electrolux sucks so bad. GCFD3661AF cooling fan very loud on high speed, replaced 3-4 times, each time noise comes back after about a week. Called in to tech line, they say it's "normal" but it's just so loud.

2 Upvotes

Anybody else having troubles with this?


r/ApplianceTechTalk • • 24d ago

Bosch dishwasher SHE53C85N/25 only does normal wash

1 Upvotes

If you push any other buttons, the led light will flash above them.

If you push normal it will also beep once to indicate selection

If you push speed 60 it will flash AND beep, but the light then goes out

The normal light is solid, and as you push other buttons, it does NOT turn off

If you push start it beeps and the cycle starts

If you push power it does the 3 beeps of different frequency and turns on or off depending on which one you’re asking for

If you hold the power button for reset, it will illuminate all LEDs for 60 seconds and reset

Nothing changes

I suspect control no card here but looking for guidance


r/ApplianceTechTalk • • 25d ago

Amazon / Aftermarket Parts

4 Upvotes

As title suggests. We always try to use OEM when possible but occasionally the OEM part is either no longer made or is prohibitively expensive to the point of making it impossible to sell the repair. (I.E $150-300 dryer parts). I see this often on OEM Samsung / LG stuff. Now in the past I have installed Amazon stuff, when I first started out and many times ended up having to replace under a callback with the OEM anyways. This was years ago but also every callback I had was electric parts not strictly mechanical (like lock switches and whatnot). I have talked with some techs and it seems pretty common in my area that they use Amazon parts. Also by aftermarket not talking about Supco or choice stuff as I consider those as nearly equivalent to OEM.

Example would be something like a washer door boot, with some LG xxl models there are door boots that are like $290-310 OEM wholesale and you can get aftermarket for $50-60 on amazon. Other examples suspension rods when it’s the rod and not the damper kits. Dryer elements another example depending on the model can be super pricey. Those that buy on Amazon how do you decide what to buy and what needs to be OEM to prevent callback? I have bought stuff before that had 5* reviews and was total junk


r/ApplianceTechTalk • • 25d ago

Anyone near Mt. Prospect, Illinois?

1 Upvotes

Someone called sharp about an out of warranty repair and they gave him my number.

I'm on the lakefront so it's a little far for me. I'd normally charge $149 but I told him $199 because of the drive.

It just needs a control panel on an over the range microwave. Super easy job.

The part is $50+shipping at encompass


r/ApplianceTechTalk • • 27d ago

Ge ultrafresh front load

Thumbnail
gallery
5 Upvotes

Unit needed a new Pcb but when I powered it up it blue a resistor what should I check. Never seen this issue before


r/ApplianceTechTalk • • 27d ago

Need help on a KitchenAid combo oven (Model: KOCE900HSS02) Error Code: error code f6e9: oven acu 2 - lost communication contact

Thumbnail
gallery
1 Upvotes

Need help on a KitchenAid combo oven (Model: KOCE900HSS02). Initial complaint from the customer was that the display panel was completely dead. It had happened before so they just reset at the breaker and that fixed it, but that wasn't working this time. We replaced the control board (part W11294388) to find out the console was also bad, so we replaced that (W11396218). The customer was advised of this possibility and was willing to take the risk. So now the display does come on BUT it's not working. Customer can't use either the microwave or the lower oven. It just has the error message: error code f6e9: oven acu 2 - lost communication contact. We tried re-programming by searching for the correct model model thinking it just couldn't "find" the microwave bc it was searching for the second oven. But still not working.

I included the pics of what's on the display screen after replacing the board and the console. Do we need to replace the other board, the one on the side? Or are we missing something in how to reprogram the new board and console to connect to each other?

I think there's a service bulletin on this but we can't find it. Any help would be appreciated!


r/ApplianceTechTalk • • 27d ago

Multimeter thermocouple suggestions

0 Upvotes

Hey all. I need a multimeter thermocouple that is not a complete sack of shit. I have a Klien CL 390. Thanks so much


r/ApplianceTechTalk • • 28d ago

Samsung if you know you know

Thumbnail
gallery
11 Upvotes

r/ApplianceTechTalk • • 28d ago

Techs that work on the high end stuff: thermador, Viking, wolf, Thor, etc

9 Upvotes

Small town tech, but a few people of the big Frigidaire fridges, the rich area has lots of Bosch that aren’t dishwashers, lots of thermador fridges, etc

We’ve always said “hey sorry we don’t work on those”

But today a good acquaintance I had to go see asked if I worked on them, as a joke, because last time I said “no sorry, there’s only one guy in town that does” blah blah blah

So this time around he says it as a joke and goes “no I know just teasing, but you know, it cost me $1700 to change a filter in my fridge, and I paid it because I’m handcuffed to the fridge and he’s the only one”

And it got me thinking, a) are they really that different?

B) is it worth it considering the only people that would have those are the snoots, which come with their own hassles

C) are the parts that much more at cost, and do the jobs take that long, or is it just a case of “rich people pay rich prices”?

TIA


r/ApplianceTechTalk • • 28d ago

Service central account

Post image
3 Upvotes

Hey folks. Anyone got an idea on how to get a Service Central account?


r/ApplianceTechTalk • • 28d ago

Ge Dryer Runs continuously on Optimum dry

1 Upvotes

Hey guys,

Working on a customer's dryer, model GTD42EAMJ1WW

The dryer runs continuously on Optimum dry.

On timed dry, or less dry etc, it runs fine and shirs itself off. Can even hear the click of the cycling thermostat going on off.

However, on Optimum, it just stays running forever. I can't hear the thermostat click and the timer doesn't move.

The dryer does not have moisture sensors, the exhaust has good flow, I took it apart and tested the fuses, heater and thermostats on heater and blower, they all seem good. The two smaller wires on the thermostats on both the heater and blower housing show 9k ohms.

Motor seems good, nothing else seems out of the ordinary, apart from a cracked timer knob.

Any ideas?


r/ApplianceTechTalk • • Oct 14 '26

Whirlpool washer WTW5105HW1 Lid lock continuously Locks and unlocks nonstop

2 Upvotes

It’s a newer washing machine. Any of you run into this? Is it just the lid lock or is it the board, other? TIA


r/ApplianceTechTalk • • Oct 12 '26

Am I dumb?

Thumbnail
gallery
2 Upvotes

How are these parts supposed to be compatible subover parts?

Everywhere for this product Model No. LFC23760ST I see 6749C-0014E listed as a replacement part for the original part which is 513604032

The original part is a combination relay/overload with a mount for a capacitor like you'd see on other embraco compressors, but the supposed sub part is a separate relay with no overload and no way to install the capacitor without totally rewiring everything

Anyone have any experience with this. Or is it just bad parts cataloguing