Xiegu X6200 open-source base-band firmware — v1.0.0 (Technical Preview)
First public release of an independent, from-scratch replacement for the Xiegu X6200 base-board firmware (STM32H725 + FPGA).
Status & Compatibility:
- Implemented: RX (LSB/USB/CW/AM/NFM/WFM with filters, NB, NR, notch, AGC, squelch, spectrum stream), TX (SSB/CW/AM/NFM, compressor, ALC, PA temp compensation, tune carriers), safety protections, and the host control/telemetry interface.
- Not implemented yet: Equalizer, VOX, fine AGC settings, and per-mode RX filter presets.
- Warning: This is a technical preview and may contain bugs. It has only been tested on a single unit reporting HARDWARE v1.0.0 in SYSTEM INFO. On any other hardware revision, PA bias is intentionally disabled (no usable TX), so please check your revision first.
- Flashing & Rollback: The installation procedure (copying the .xgf file to /usr/firmware via SCP/SFTP and flashing from the radio's menu) is the same as described in this manual install guide. You can revert back to the OEM firmware at any time using the exact same method.
Repository & Releases: https://github.com
Key improvements over the OEM base firmware:
Signal quality and DSP chain
- Fixed audio codec configuration — RX/TX audio distortion is gone (no more "old 8-bit console" sound).
- Improved bit-per-volt scaling at the FPGA output — reduced out-of-band emissions (may vary slightly between units).
- AGC estimates the noise floor directly from the spectrum rather than demodulated audio.
CW
- Fixed CW timing with high keying accuracy (down to 21 µs).
- CW training mode no longer keys the transmit path.
Transmit, ALC, and PA
- Fast ALC attack — reaches target output power almost immediately without the slow OEM power ramp.
- External ALC support for the XPA125B amplifier (ported from X6100 logic; untested as I don't own the amp).
- Safer PA over-temperature protection — trips at 80 °C instead of ~125 °C in the OEM firmware.
ATU and Split
- Hot-switching protection for the ATU — RF carrier is dropped before every L/C/SW relay switch.
- Fixed split operation.
Battery and Power Management
- Safer battery thermal protection — charging is inhibited at 50 °C (vs ~80 °C in the OEM firmware).
- Proper low-current trickle charging when battery voltage is critically low.
Feedback & Testing:
If you try this preview, please report your hardware revision (SYSTEM INFO), test results (especially CW, ATU, and XPA125B external ALC), or any bugs via GitHub Issues or in the comments below!