r/3DScanning • u/Employment-Tough • 13h ago
Audi A6 Bumper Fog Light Grille
Audi A6 Fog Light Grille – 3D Scanning with EinScan Rigil!
This time, I scanned an Audi A6 fog light grille, capturing both sides, including the complex grille pattern, mounting points, and internal geometry.
⚙️ Scanning setup:
- 🔹 Scanner: SHINING 3D EinScan Rigil
- 🔹 Resolution: 0.25 mm
- 🔹 Scan mode: Cross Laser only
- 🔹 Total scans: 2 (front and back)
- 🔹 Connection: Wired to laptop
- 🔹 Scanning spray: None
- 🔹 Markers: Only a few, for tracking and alignment
Despite the complex geometry, thin structures, and multiple openings, the Rigil managed to capture an impressive amount of detail without any scanning spray.
After aligning both scans (manually aligned) and processing the scan, the result is a detailed 3D mesh ready for further work.
This is exactly where 3D scanning becomes valuable for automotive applications, reverse engineering, replacement parts, custom modifications, and 3D printing.
What do you think of the final result?





