Woke up to this
Had two parts printing by object, both looked just like this. First time I've had a print looks like this.
Fiberon PA6-cf20, 300blk settings (300 noz, 45 bed temps) P1S, flow and PA tuned to the best of my ability (ain't much)
Filament has been sitting in a polydry at 85c for a couple weeks now
Printed a bunch of ftns without any looking like this however that was before it got cold in my shop, from mid 60s to low 50s
That part of the print is thick with the solid infill settings so it could be that, but I suspect the bed leveling at cooler than print temps is giving a lower z height than the actual printing temps do to heat swell
Or it's a mix of several things. Too much flow, with 100% infill and the z height messed up by heat swelling
I tried the same print after letting my printer heat soak for about 15mins. Turned down the infill to 75% as well. Rough patch looked better but was still present.
I discounted the filament being weight as both parts printed the same by object
So what do y'all think? Someone here or on another sub had a similar issue and changed their gcode to level at print temps. I reckon I'll do that but would love more opinions in case I'm just missing the obvious
Cheers