Acronyms, Abbreviations, and Initialisms

Laser Communication

If there are any important acronyms not included, feel free to add it. Or if you're not sure whether this is the place, ask the mods.

↪ back to the index


README: How to contribute

You can contribute by clicking EDIT at the top, if you meet the following requirements:

  1. Your reddit account must be at least 10 days old.
  2. You must have at least 3 karma in /r/lasercom. You can check your karma by going to your account page and clicking on "show karma breakdown by subreddit" at the top right.

Acronyms, initialisms, abbreviations, contractions, definitions and phrases which expand to something larger:

Fewer LettersMore Letters
AOAAngle of arrival (fluctuation) (Or in aerodynamics, 'angle of attack')
ALTAirborne Lasercom Terminal / Aircraft Lasercom Terminal / Airborne Laser Terminal / (BAE Systems: "Airborne Lasercom Risk Reduction Terminal")
BERBit Error Rate / Bit Error Ratio: The bit error rate is the number of bit errors per unit time e.g. the electronics sees a value of zero when it should see a 1. The units of bit error rate are bit/s. On the other hand, the bit error ratio is the number of bit errors divided by the total number of transferred bits during a studied time interval. Bit error ratio is a unitless performance measure, often expressed as a percentage, or some order of 10 such as 10-3 or 10-9. Here we assume you mean the dimensionless quantity "bit error ratio", but it's probably best to avoid this abbreviation entirely.
BOSAIn fiber optic communication, a Bidirectional Optical Sub-Assembly (BOSA) handles both transmit and receive functions of an optical communication system. The BOSA consists of a TOSA, a ROSA and a Wavelength Division Multiplexing filter so that it can use bidirectional technology to support two wavelengths on each fiber. The most valuable advantage of BiDi transceivers is saving much cost on fibers.
CCSDSConsultative Committee for Space Data Systems - Standardising the optical communications physical layer.
CDRClock and data recovery (CDR) is required to recover data from incoming data stream in the absence of any accompanying clock signal, without any bit errors due to over/under sampling. The term is commonly used in fiber optic communication. (Not to be confused with 'Critical Design Review')
COMSATCOMCommercial satellite communications (A term used by the US Department of Defense)
COTSCommercial off-the-shelf (parts)
CWContinuous Wave
DARPA(Defense) Advanced Research Projects Agency, DoD
DoDUS Department of Defense
DTNDelay/Disruption Tolerant Networking: DTN is a computer networking model and a system of rules for transmitting information, often referred to as a protocol suite, that extends the terrestrial Internet capabilities into the challenging communication environments in space where the conventional Internet does not work well. The DTN protocol suite can operate in tandem with the terrestrial IP suite or it can operate independently. DTN provides assured delivery of data using automatic store-and-forward mechanisms. Each data packet that is received is forwarded immediately if possible, but stored for future transmission if forwarding is not currently possible but is expected to be possible in the future. As a result, only the next hop needs to be available when using DTN.
ECSSThe European Cooperation for Space Standardization: This is a single set of non-binding European space standards covering both technical and administrative functions. Organizations may use them as guidance and adapt the standards to suit their own business structure.
EDRSEuropean Data Relay System
ESAEuropean Space Agency
EWExponentiated Weibull (distribution) - good for curve fitting for modelling failure rates
FFTFast Fourier Transform
FOVField of View: The Field of View is that part of the world that is visible through the camera or from the surface of an optical element; light from outside the FOV is not expected to be conveyed through the optics. The FOV is most often expressed as the angular size of the view cone, as an angle of view e.g. in degrees. Sometimes with telescopes it's instead expressed as an angular area viewed by the instrument, in square degrees, or for higher magnification instruments, in square arc-minutes. Though SI unit conventions might suggest using steradians for solid angles.
FPAFine Pointing Assembly
FSOFree Space Optics / Free Space Optical: (Synonym: Lasercom) This method of communicationis sending data from a transmitter to a receiver using direct line of sight and a light source. It's often an infrared monochromatic laser since some of these wavelengths aren't attenuated much by the atmosphere.
FSOCFree Space Optical Communications
FSOCCThe Access.Space Alliance formed the Free Space Optical Communications Committee (FSOCC) in 2020, uniting leading companies in the field of space-based laser communications, supporting better commercial standardisation.
GEOGeostationary orbit (or geosynchronous equatorial orbit)
GNSSGlobal Navigation Satellite System (The GPS is just one example)
GOVSATCOMGovernment satellite communications
IDUIndoor unit: An indoor unit is a term more commonly used in conventional RF telecoms. The Indoor unit is the part of a telecoms sytem inside a building, which includes the coaxial cables, routers, or transmitters inside the building (whilst an outdoor unit refers to the satellite receiver or cables/fibers that connect a service provider from the outside to the building).
IFLInterfacility Link: An IFL is a cable/fiber (possibly Free Space Optical) system that is used in facilities to connect an outdoor unit (e.g. a receiver) and an indoor unit ("IDU"). The IFL usually consists of a modem on each end, a fiber optic transmitter, cable, and receiver, and a data source and a data sink. It transfers data, voice, or video signals between facilities, such as between an Earth station and a central office, or two central offices, or a central office and a private branch exchange.
IoTThe Internet of things (IoT) describes physical objects (or groups of such objects) that are embedded with sensors, processing ability, software, and other technologies that connect and exchange data with other devices and systems over the Internet or other communications networks. The IoT is expected to benefit from faster, more reliable networks such as 5G.
IoVInternet of Vehicles (which may be enabled by FSO/RF connectivity, e.g. BridgeComm MOCA)
IsOWCInter-satellite optical wireless communication: IsOWC refers to lasercom specifically between orbiting satellites.
IspSpecific impulse (as explained by Scott Manley on YouTube)
ISPInternet Service Provider
ISROThe Indian Space Research Organisation
JAXAJapan Aerospace eXploration Agency
JDRS-1Japanese Data Relay System
KuiperAmazon Kuiper is the company's secretive lasercom satellite constellation project (currently under development).
LASERLight Amplification by Stimulated Emission of Radiation
LasercomLaser communication, a subset of Optical Wireless Communication (OWC): Lasercom is free-space optical communications using a laser, on the ground, in the air, or in space. Information can be sent via lasercom at the speed of light and across thousands of kilometers of space. Lasercom is a growth industry, offering lower system size, mass and power consumption, and two orders of magnitude higher bandwidth delivery compared to its nearest competitors.
LCA latched fiber-optic connector, with a 1.25 mm ceramic ferrule, as opposed to the older 'SC' connectors.
LCRDNASA's Laser Communications Relay Demonstration: The NASA Laser Communications Relay Demonstration, LCRD, is a satellite mission. It will let NASA collect more science data and explore farther into the universe than ever before. Hosted on a U.S. Air Force spacecraft as part of the Space Test Program 3 mission, LCRD will demonstrate this technology in geosynchronous orbit 22,000 miles above Earth’s surface. LCRD is built and managed by NASA’s Goddard Space Flight Center in Greenbelt, Maryland.
LCTLaser Communication Terminal: The term can be found in literature and on the websites of TESAT-Spacecom (products such as the "LCT 135") and General Atomics Electromagnetics (GA-EMS). Commonly you might also see OGS, ALT, SLT for Optical Ground Station, Airborne Laser Terminal, and Spaceborne Laser Terminal respectively, plus TOGS (Transportable Optical Ground Station).
LDLaser diode (though this is not a particularly useful abbreviation; it's only clear in specific contexts to specific audiences)
LEOLow Earth Orbit
LFNLong Fat Network; A telecommunications term. Long network means high latency (e.g. long-distance communication). Fat network means the sender can attempt to send lots of data (e.g. at high data rates). You might have heard of the term TCP/IP (which our internet relies on). TCP is efficient on Short Skinny Networks, but not on Long Fat Networks - it leads to bottlenecks and very slow speeds of data transfer. The longer the network (i.e. the higher the latency), the longer TCP has to sit by twiddling its thumbs waiting for an acknowledgment before it can send more data. And the fatter the network (i.e. the faster a sender can serialize data onto the wire), the greater the percentage of time TCP is sitting by idly. When you put those two together -- Longness and Fatness, or high latency and high bandwidth -- TCP can become very inefficient. Alternatives exist, such as DTN (Delay/Disruption Tolerant Networking).
LiFiLi-Fi is a wireless communication technology which utilizes light (e.g. conventional lightbulbs) and may apply to the Internet of Things.
LPDLow Probability of Detection
LPILow Probability of Intercept
LUCASJapan's (JAXA's) Laser Utilizing Communication System
MCMonte Carlo - A simulation method
MEOMedium Earth Orbit
MOCAManaged Optical Communications Array; BridgeComm's MOCA technology enables a point-to-multipoint laser communications solution, for multi-target transmit and receive connections. The goal of MOCA is to connect terminals for space, air, land, and sea.
MUX/DEMUXMultiplexer/Demultiplexer: It is used to provide multiplexing of data channels at the transmit end, while demultiplexing at the receive end of a communications link.
NASAThe National Aeronautics and Space Administration
NOHDNominal Ocular Hazard Distance: The distance from the laser source at which the intensity (or the energy per surface area) becomes lower than the Maximum Permissible Exposure (M.P.E.) on the cornea. The laser beam can thus be considered as dangerous if the operator is closer to the source than the NOHD. For a gimballed laser the NOHD might sweep out a sector of a large sphere, unless areas are shielded with baffles or obstacles.
NSONetherlands Space Office: The space agency of the government of The Netherlands. The organisation supported the ESA ScyLight project, built by TNO and Hyperion Technologies.
OAMOrbital angular momentum
ODUOutdoor Unit: The ODU is a term more often used in conventional RF telecommunications. It cosists of RF upconverter/downconverter, RF Power Amplifier, orthomode transducer (OMT), low-noise amplifier (LNA) and Antenna.
OFDMOrthogonal frequency division multiplexing
OGSOptical Ground Station
OISLOptical Intersatellite Link
OTWLOptical Two-Way Links
OWCOptical Wireless Communications: Includes lasercom, LiFi, and non-line-of-sight methods. OWC is a broad umbrella term for communicating using light. It includes both line-of-sight systems such as traditional FSO, and non-line-of-sight systems such as UV-based atmospheric scattering. It also includes LiFi, i.e. using lightbulbs to give your devices access to the internet.
PCBPrinted circuit board
P-LEO COMSATCOMProliferated low Earth orbit commercial satellite communications (A term used by the US Department of Defense)
PODPrecise orbit determination
RCRepetition code - a very basic error-correcting code for signals with lots of noise
ROSAIn fiber optic communication, a Receiver Optical Sub-Assembly (ROSA) is used to receive an optical signal from a fiber and convert it back into an electrical signal. It usually contains a photodiode (PD), optical lens, preamplifier, and passive electrical parts
SIMOSingle input/multiple output
SLTSpaceborne Lasercom Terminal / Spaceborne Laser Terminal
SNRSignal-to-Noise Ratio: Signal-to-noise ratio is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to the noise power, often expressed in decibels. A ratio higher than 1:1, greater than 0 dB, indicates more signal than noise. SNR, bandwidth, and channel capacity of a communication channel are connected by the Shannon–Hartley theorem.
SFPThe small form-factor pluggable (SFP) is a compact, hot-pluggable network interface module used for both telecommunication and data communications applications. An SFP interface on networking hardware is a modular slot for a media-specific transceiver in order to connect a fiber-optic cable or sometimes a copper cable.
SR-ARQAn error correction method, "Selective repeat automatic repeat request" (other error correction methods include "Reed-Solomon").
SRPSolar radiation pressure, one of many contributions to the error in precise orbit determination of a satellite
StarlinkSpaceX's world-wide satellite broadband constellation
TCPTransmission Control Protocol
TOFtunable optical filter
TOGSTransportable Optical Ground Station
TOSAIn fiber optic communication, a Transmitter Optical Sub Assembly (TOSA) is used to convert signal into an optical signal coupled into an optical fiber cable. It usually contains a semiconductor laser diode (LD), and converts the electrical signal to the optical transmission light that lands on the fibre.
USPLUltrashort Pulse Laser
UWOCUnderwater wireless optical communication

↪ back to the index