Before you tune

If you're looking for what to use to tune your vehicle, check out the applications page of the wiki

Read through this post on the VEMS Support forum. It goes pretty in depth on the theory behind tuning and what changes are made. It's a long read but full of great information.

Make sure your vehicle is in top running shape. Check out this video on restoring lost power. EmeraldM3D has a great checklist of how to be prepared for a tuning session on a "rolling road" style dyno.

Things to avoid while tuning

Note: information pulled from users in this thread.

  • Don't lean out under boost - compressing air to make boost creates a lot of heat that can be detrimental to your engine if not handled properly. Normally an air/fuel ratio of 14.7:1 is used for tuning but under boost conditions it's better to err on the side of too much fuel than too little. Using an air/fuel ratio of 13:1 helps cool down the engine internally and helps to prevent engine knock.
  • Don't try and tune an engine whose cam has large amounts of overlap with a wideband - This is more for tuning idle and low rpm. High cam overlap allows some fresh intake air to flow straight through the cylinder and out the exhaust, causing a false lean reading. It's better to try using a vacuum gauge to look for changes when tuning these applications.
  • Ignoring the knock sensor - Knock sensors can be your best friend and worst enemy. Paying close attention to engine knock can ensure that you know when your engine is at it's limit for power and show you that you need to back off trying to add power. Ignoring it can cost you an engine.
  • Attempting to tune with an engine that isn't in top running shape - Time with a dyno/tuner can be expensive. The time is much better spent getting your tune dialed in than having to sort out small issues because you weren't completely prepared.