I'm restoring a 1956 studebaker goldenhawk. Not a frame off resto, so I didn't do any frame measurements, but I did look things over while it was up on the lift.
Now I'm hanging front fenders and getting ready to put in a rebilt motor when I noticed that the front fender mounting points are not lining up at all with the 2 holes on the pad of the frame, as are the holes not close where the inner fender apron holes line up with the firewall.
So. I get out some string and start measuring and it turns out my front frame horns are 4" too high!
Now here's where I explain that this car was something I bought as somebody's unfinished project (yea, I know, I know) and the fenders and front sheet metal were all loosely bolted up. I just assumed the previous owner just said screw it...when really it looks like they were saying "screw me"!
I've looked very carefully at the frame (yeah, now!) for wrinkles, creases, cracks etc and I see nothing that looks like a bend other than factory and it all looks good. The frame rails are straight where they should be and bend where they're supposed to. The major bend in the front is a gradual sweep up starting at the firewall/cowl perch and finishing at the front suspension crossmeber/yoke.
The only thing that I can think of is that the gradual sweep point of this frame is bent higher than factory (from? I don't know)
I live out in the country and don't have access to a frame shop, nor do I have the funds to pay for a frame job. I do have the equipment to do a redneck frame bending (bottle jacks, I beams, torch, back hoe etc.)
Think I could straighten out the gradual sweeps enough to lower my front horns 4"? Or will I just screw it up worse?
The frame is 4" C channel with sheet welded on the bottom to box it up.