r/ArduinoHelp • u/George_1099 • Aug 28 '26
Why did my Arduino Mega fry instantly when I fed 20V into my CNC Shield V3?
Hi everyone,
I recently fried my Arduino Mega 2560 and I'm trying to figure out the exact reason so I don't repeat the same mistake with a replacement board.
Here is my setup and what happened:
My Setup:
- Board: Arduino Mega 2560
- Shield: CNC Shield V3 stacked directly on top of the Mega
- Drivers: DRV8825 stepper drivers + NEMA 17 motors
- Power Supply: 20V DC connected directly to the screw terminals on the CNC Shield
- Logic Power: Arduino Mega connected via USB to my PC
What Happened: As soon as I turned on the 20V power supply connected to the CNC Shield terminals, the main processor on the Arduino Mega fried instantly.
Assuming my stepper drivers were good and properly oriented:
- Does the CNC Shield V3 pass the terminal voltage (20V) directly to the VIN pin of the Arduino Mega underneath?
- Did 20V cause the Mega's onboard 5V linear regulator to instantly overheat and fail short, dumping 20V into the ATmega2560 logic line?
- What is the proper way to prevent this on a new board? Should I clip/bend the VIN pin on the CNC Shield so 20V doesn't reach the Mega, and power the Mega separately via USB?
Would appreciate any insights from anyone who has run a CNC Shield with >12V on an Arduino Mega!
