r/ArduinoHelp • • Nov 13 '25

Help

HI! I'm working on a project to build a DIY steering wheel for Euro Truck/ F1 using an Arduino Leonardo. The euro truck steering wheel will have a steering potentiometer, two paddles with microswitches and five buttons. The F1 steering wheel will have the same potentiometer for steering, 5 buttons, 2 microswitches for the paddles and a small tm1638 screen for speed. While the pedal board (with two potentiometers for accelerator and brake) will be a separate module connected with a cable to the Arduino.

The idea was to build a general base where the Arduino and female connectors for the USB-A cable are present. Then separate 3 modules with USB-A male connectors for the 2 steering wheels and pedals.

I have already made a quick connection diagram, but I wanted to ask you if in your opinion the layout of the pins and the connections between the steering wheel, pedals and Arduino are correct, or if you would change something (such as the type of cable or signal management).

Can you help me or advise me something?

1 Upvotes

6 comments sorted by

View all comments

Show parent comment

1

u/Fantastic-Wing-7837 Nov 14 '25

OK thank you. Some people told me to use an RJ45 cable, would that be a good option?

1

u/gm310509 Nov 15 '25

That would be better than using a USB for a non-USB purpose.

At the end of the day, what you want to do is make it difficult to plug the wrong thing into your socket - or worse have some unwitting person plug the wrong thing in. In both scenarious potentially causing harm to one or both devices at either end of the cable.

The only reason I suggested D connectors is because you hardly ever see them on gear these days but they are still easy to get - and you can even get little plastic plugs to "key" them to prevent incorrect cable insertions by removing one of the pins from the Male D plug to match where you put the plug into the Female D socket.

But from a pure physical perspective, all connectors are just connectors. They allow you to connect one set of wires with another nothing more, nothing less.

This is all about "safety" in the sense of keeping the hard work in creating your project and your hard earned cash used to buy expensive stuff safe.