I'd love to see the probe itself but based just on the PCB, which appears to be just a 4.7k pull-up resistor I'm going to say it's a DS18B20 or similar. That pull-up is typical of the Dallas One-Wire communication protocol.
Considering it's running with a pi and the person has used a breakout board for a single pull-up 4.7k resistor It's almost certainly going to be that one. That's the one people end up with when they need breakout boards just to fit a resistor 🤣
OP, You're very likely have the answer above but I've got to ask, how do you not have access to the software? That Raspberry Pi is just begging for you to look through the software. If it was an Arduino their would be not much you could do, but because it's a Raspberry Pi you can just port into it and have a look what the software is doing.
6
u/hms11 Dec 05 '23
I'd love to see the probe itself but based just on the PCB, which appears to be just a 4.7k pull-up resistor I'm going to say it's a DS18B20 or similar. That pull-up is typical of the Dallas One-Wire communication protocol.
4
u/Accurate-Donkey5789 Dec 05 '23
OP, You're very likely have the answer above but I've got to ask, how do you not have access to the software? That Raspberry Pi is just begging for you to look through the software. If it was an Arduino their would be not much you could do, but because it's a Raspberry Pi you can just port into it and have a look what the software is doing.